Codes that name it
Amana
- Amana furnace EE0:
Igniter that needs replacement or realignment
Amana and Goodman *CVC96 / *MVC96 two-stage furnace installation instructions (IOG-2015L) (opens in a new tab) ↗ - Amana furnace EE7:
Problem with the igniter circuit
Amana and Goodman *CVC96 / *MVC96 two-stage furnace installation instructions (IOG-2015L) (opens in a new tab) ↗
American Standard
- American Standard furnace E2.1:
The same guide's heating sequence says the ignitor warm-up is about 20 seconds and flame must be sensed within 4 seconds
American Standard S9V2 installer's guide (18-CE01D1-1E-EN) (opens in a new tab) ↗ - American Standard furnace E6.3:
Igniter relay failure
American Standard S9V2 installer's guide (18-CE01D1-1E-EN) (opens in a new tab) ↗
Bryant
- Bryant furnace 14:
Count 1 short flash and 4 long flashes. The same manual's sequence says the hot-surface igniter warms up for 17 seconds, then a 2-second flame-proving window follows. Failed trials repeat, then the control goes to ignition lockout
Bryant 926TB installation, start-up, operating and service instructions (opens in a new tab) ↗
Carrier
- Carrier furnace 14:
Defective hot surface igniter
Carrier 59SC5 installation, start-up and operating instructions (opens in a new tab) ↗ - Carrier furnace 34:
Defective hot surface igniter
Carrier 59SC5 installation, start-up and operating instructions (opens in a new tab) ↗
Goodman
- Goodman furnace EE0:
Igniter worn or misaligned
Goodman GR9S96/GD9S96 installation and operating guide (IOG-2037B) (opens in a new tab) ↗ - Goodman furnace EEL:
Improperly connected or shorted igniter
Goodman GR9S96/GD9S96 installation and operating guide (IOG-2037B) (opens in a new tab) ↗ - Goodman furnace EEn:
Igniter wiring problem
Goodman GR9S96/GD9S96 installation and operating guide (IOG-2037B) (opens in a new tab) ↗
Rheem
- Rheem furnace 11:
Igniter not working, not connected or mispositioned
Rheem R96V installation instructions (92-24161-124-03) (opens in a new tab) ↗
Trane
- Trane furnace E2.1:
Igniter position
Trane S9V2 Service Facts (S9V2-SF-2A-EN) (opens in a new tab) ↗ - Trane furnace E6.3:
Igniter relay stuck on control
Trane S9V2 Service Facts (S9V2-SF-2A-EN) (opens in a new tab) ↗
York
- York furnace 7 red flashes:
Faulty hot surface ignitor
York TG9S installation manual (Johnson Controls 1083287-UIM-C-0715) (opens in a new tab) ↗
Search for this part
The button opens an Amazon search for the part name. It does not confirm a fit for your model, and it does not make the repair a homeowner job. Gas, venting and line-voltage work belongs to a licensed technician.
As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure
Safety first
Unplug the furnace or switch it off at the breaker, and shut off the gas supply where relevant, before you open any panel. Capacitors can hold a charge after power is off. Gas, electrical-panel, refrigerant and carbon-monoxide work belongs to a licensed professional. Follow the manual for your model (safety terms).