We may earn a commission from links on this page. Learn more about affiliate links

Trane E08: Low flame current, but still strong enough to allow operation

Ref. TRANE-E08 · From the Trane furnace manual · Updated 2026-10-23

Status codeE08Trane
What it means

Low flame current, but still strong enough to allow operation.

Call a profurnace
How it shows: 7-segment display alternates with mode: E08

Find a local HVAC pro →

§1Likely causes

  • Flame sensor location incorrect
  • Burner flames not directed into the heat exchanger
  • Faulty flame sensor
  • Wiring or connections

§2Safe DIY steps

  1. Technicianmeasure flame current across FP pads
  2. Techniciancorrect flame sensor location or replace sensor; check wiring
Safety firstIf you smell gas, do not touch any electrical switch or use a phone in the building; leave immediately and call your gas supplier from outside. Turn off electrical power at the furnace switch or breaker before opening any panel, and never bypass or jumper a limit, rollout or pressure switch. Gas valve, burner, venting, wiring and control-board work should be done by a licensed HVAC technician.

§3When to call a pro

Call a licensed HVAC technician: to service the flame sensor before it causes lockouts.

Find a local HVAC pro →

§4Other Trane codes

E01Trane

Loss of the IRQ or other internal failures (internal furnace control error).

E04Trane

Open limit: main thermal limit, flame rollout switch, or reverse airflow switch.

E05Trane

Flame detected when it should not be present.

E06Trane

Voltage reversed polarity or bad grounding.

E09Trane

Open inducer limit switch or condensate pressure switch.

E12Trane

Open fuse: the onboard 5 amp fuse is open or missing.